Wood Preservation Methods
The Biological research of wood and it’s renewable material is what is referred to as wood science. The processes and the tools used to utilize the material is what is known as wood technology. Wood is treated as a material in direct comparison with other products. The comparison made against other products will include the features of the material against those of wood, the value and the ease it can be worked on. The utilization of technology gives wood an upper hand in most of this comparison. Some of these advantages include wood being a versatile material that can be used in a wide range of products. Once a tree has been cut down another can be planted in the same spot. Timber can be utilized in very many applications, and this makes it more valuable.
Protection of wooden structure and products is a must if you want to keep the good looks in place. Wooden structures have to be kept away from water and pests that eat through the wood. The rotting and decay of the timber products are caused by the moisture and the insects. There are many ways timber is treated among them being the ACQ in other words alkaline copper Quaternary. As the name implies the preservative is made of copper products. Although being a good method to use for wood protection it has presents some few challenges. It has been seen corroding most metals for example aluminum in less than six months of its application. The saturation level of any treatment will depend on where the wood is going to be used and the species of the wood. The level of chemical concentration will be determined by where the piece of wood is going to be put to use.
Another wood treating method that is fast being accepted is the use of copper metal. This method is being accepted fast because is friendly to wooden fasteners. Micronized copper wood preservative is the correct term to refer this type of preservation. In this process microscopic particles of solid copper metal are mixed in a liquid carrier and injected to the wood at high pressure. The process eliminates the need to dissolve the copper as is done in earlier copper-based preservatives. When this process is used to treat timber the timber properties are increased highly. The timber treated in this way is used in both outdoor and indoor frames that last very long.
Termites and fungal decay are just a few among the many problems wood treated from this method are protected against. It is not corrosive to metals used in together with the product. The wood treated using this method last longer and is stronger.